Rheem 400 Litre Electric Hot Water System Supplied & Installed

What is included in the Rheem 400 Litre hot water valve Kit?

1x 15mm Non-Return Isolating Valve (AVG or RMC Brand)

1x 15mm Tempering Valve (AVG or RMC Brand)
1x 15mm Pressure Reduction Valve (AVG or RMC Brand)
1x 15mm Expansion Control Valve (AVG or RMC Brand)
2x Hot Water System Brass Elbows (Cold Inlet & Hot Outlet)
2x 15mm x 1/2″ Male Compression Unions
1x 15mm Compression Tee
1x 15mm FI Centre x Compression Tee
1x Length of 15mm Copper Tube
2x Lengths of Copper Lagging
1x Valve Lagging Kit

What is a ‘standard’ install?

• Supply new hot water system – Normally day prior to installation
• Isolate water service and disconnect existing hot water system
• Electrical disconnect & reconnect (only)
• Install new Valves (if selected)
• Position new hot water system on existing base and connect to existing water service
• Run PTR & ECV Drain lines in accordance to Australian Standards
• Lag copper pipework and secure according to AS3500
• Disposal of existing hot water system & rubbish
• Submit Form 4 to local Council

Please note:

– If further work outside this scope is required, additional costs will be chargeable to the customer at the discretion of the attending technician(s)
– Hot water system must be on a stable base elevated above the finished ground to prevent pooling of water around the hot water unit, supply of a base will incur additional costs
– If drain lines are required to be extended or non-complaint, additional costs will incur
– If the hot water system needs to be relocated, additional costs will incur
– If extra valves require replacing, additional costs will incur – This is at the discretion of the attending plumber
– If the electrical circuit, RCD or other components need to be upgraded or replaced to be compliant, additional costs will incur

For further information on Inclusions & Extras please click – HERE